1.1  Port Basic Parameters

You could set up several parameters including Speed,Duplex, Flow Control, Protected.

1.2  Port Advanced Parameters

Only the flow duplex is enabled could you set up parameters.

You could set up flow duplex for each port in this parameter.

Usually, if the port is not the carrying VLAN member of receiving packets, the packet will be discarded. Enabling VLAN transparent transmission,
the packet is not dropped and will be forwarded in the packet carrying VLAN.

1.3  Configure Port Mirroring

Enable port mirror, mirroring the ingress of source port FE1/2 and egress of source port FE1/3 into destination port FE1/1

1.4  Link Aggregation

Put port FE1/1, FE1/2, FE1/3, FE1/4 into trunk 1

  VLAN can be flexible on the physical network into logical. Different VLAN cannot communicate directly, which to some extent, it ensures data and
  information’s security. The operation is simple, you just need to choose divided VLAN port and the type of transmitted data frames.

               f

3.1  RSTP

Enable RSTP protocol and set up parameters according to your requirements.

3.2  G.8032

When you configure it, pleas pay attention:

1)        Cut off topology link ring

2)        Set up switch step by step

3)        Save configuration after setting up

4)        Make sure physical ring link isworked

Please pay attention to the four points mentioned before, otherwise broadcast storm will be happened and make link bandwidth traffic severely. Left port is FE1/7 and right port is FE1/8 as default. Before you set up, please configure one owner joint.

In the ring network topology, other joint are set up to normal joint.

  Port Security provide the particular MAC address ability of receiving or filtering flow. You can set up advanced parameter of port through clicking each port.

        

You can set up secure MAC and the number of address due to
your site requirements. Pay attention: format of MAC address should be
HHHH.HHHH.HHHH.

            

5.1  Queue

QoS could guarantee high-priority data frames received and accelerate high-priority data frames to send, to ensure that critical business will not be
influenced by network traffic. You could set up VLAN’s priority and default configuration due to your site requirement.

5.2  QoS

You could set up priority of business data.

In the policy option, wrr queue 3:2:1:0 matched weight is 8:4:2:1 sp. IGMP Snooping user could set up following items:

1)        Enable IGMP Snooping

2)        Choose filtering route port you need

3)        Choose filtering business VLAN